turbine alignment
2-day centralign (SYSTEM2) class
Objective
Turbine diaphragm alignment with CENTRALIGN (SYSTEM2)
Syllabus
• Introduction
• Measurement Objectives
• Review Components; proper storage, specifications
• Bracketing
• Setting Sensor Addresses
• Power and Cabling Options
• Programming Sensor Addresses/Averaging
• Software review (Dimensions, Measure, Results) and Soft Keys.
• Overall Procedure; Long Range/Short Range
• Practice data collection on Simulator using Static Mode
• Discussion
• Resolution, Repeatability, Accuracy
• Tolerances (Compressors, Gas Turbines, Steam Turbines, Stern Tubes, etc.)
• Measuring Modes and applications
• Practice data collection on simulator with Multi-point
• Presets and Line Presets
• Reporting and Excel downloading
• Field use (time and facilities dependent) |
Requirements
Student should have alignment experience in general; some exposure to the laser alignment system would also be helpful but is not required..
 Request training information
|
